Final Test- 8 Hr Refresher

The nickname for the HazCom standard is:

What is the goal of the Hazwoper Standard

First Responders at the Awareness/Incident level may clean up small spills of hazardous materials as long as the PPM of the material does not exceed:

OSHA defines a label as written, printed or graphic material displayed on or affixed to container of hazardous materials

Flammable substances have a higher flash point than Combustible substances

SEMS applies to which of the following types of operations offshore?

Acidic substances have a PH of:

What is the difference between acute exposures and chronic exposures?

When mixing substances not of the same PH, you should always mix into the substance with the pH closest to 7 pH

SEMS requires training for all personnel ensure that personnel can _________

When measuring vapor density, my constant is always?

The blue diamond on the NFPA 704M hazard identification system is for:

Flammable liquids are in hazard class?

The most common route of hazardous material entry into your body is:

1% is equal to 1,000 PPM

A substance that can yield its own oxygen to stimulate combustion is know as a (an):

Which hard hat Class offers the maximum level of protection to the wearer?

A Short Term Exposure Limit is measured over what period of time?

Name the Three zones of a Hazmat incident

What types of facilities on the Outer Continental Shelf (OCS) are subject to the SEMS rule?

Where is the employer’s written HazCom program required to be?

In an accident investigation, which is NOT one of the three (3) levels of accident causes:

Deceleration Devices may be no longer than:

Fall Protection systems include:

When lifting objects you should mainly use your:

The lowest level of PPE protection requiring an SCBA is:

Ergonomics is about:

According to the OSHA standard on Electrical Safe Work Practices [29 CFR 1910 Subpart S], only _________ may repair, replace, troubleshoot or maintain electrical equipment or systems

Hearing protection must be worn when the employee’s noise exposure may exceed ________ as averaged over an eight hour day

Tagout:

Those employees who physically lockout equipment for service or maintenance

If three people are needed to work on a piece of equipment:

Only Affected Employees may perform lockout/tagout

What does SEMS stand for?

After controlling stored energy, the next step is to:

The first things we do to control hazards in the workplace are:

The last things we do to control hazards in the workplace are:

Fixed anchor points must be capable of dead weight of:

When unqualified employees are working near overhead power lines, always:

Which statement about GFCI’s is NOT true?

When working above 6′, it is okay to unfasten lanyards from anchor points as long as there is a ladder within 5′ of the employee

When working near exposed energized parts, it is best to:

Employees should inspect electrical equipment

Burned out fuses may be replaced with aluminum foil to keep circuits closed as long as it will take no longer than one (1) hour to acquire a replacement fuse with the proper amperage

When a work team completes a JSEA before a job, it helps them identify hazards and plan how to mitigate them before someone can get hurt from those hazards

If a chemical listing is highlighted in the North American Emergency Response Guidebook, you turn to the _______ pages to find out evacuation distances

List one component of the employer’s written HazCom program

What does the term IDLH stand for?

SEMS Management of Changes does NOT apply to which of the following:

Who has Stop Work authority?